BIOS update for Biostar M6TFX motherboard

[cp]

Recommended by Wim's BIOS...

[cp]

ahhhm..no! you have to measure the signals against Vss

1.5v on V_1.5(AD36)
0v on V_2.5(Z36)

[cp]

did you measure the vcore already? that's what i would try next.

Yes, 1.7 volts

[cp]

okay, measure PWRGOOD again and if it still is 0V you can try shorting it to Vcc. make sure to short it somewhere against a Vcc with a voltage level above 2,5V

I’m not getting any voltage when I test PWRGOOD against VCC. However I am getting 1.7-volts when I test the PWRGOOD pin against the VSS…

I didn’t try shorting PWRGOOD and VCC since I'm not getting any voltage..

[cp]

i never told to test anything against Vcc which is the positive supply voltage. Vss is ground or the negative supply voltage.

look, you tested PWRGOOD against Vcc and you got 0V. this is absolutely correct since Vcc is 1,7V (against Vss) and PWRGOOD is 1,7V (against Vss),too. So the difference between those two voltages is 0V.

and as i already suspected in my 1st post 4 month ago: the mainboard is supplying Vcc to PWRGOOD. since Vcc is 1,7V and PWRGOOD requires at least 2,5V the cpu will just sit there and wait for PWRGOOD to rise to 2,5V.
so if you want a running system you have two options:

1. cut the trace to the PWRGOOD pin on the Slot1 adapter somewhere near the socket 370. build a linear regulator that will transform 3,3V into 2,5V and supply it to Vcc2,5. now short Vcc2,5 to PWRGOOD.

2. get a slot adapter that has the 2,5V regulator already onboard. cut the PWRGOOD trace somewhere near the socket and short it to Vcc2,5.

done.

If I'm going to try option one, where do I get 3.3volts from?

[cp]

you can use Vcc5 (5V) on pin B109 or VccL2 (3,3V) on pin B121, B113 on the slot1 side.