Emachines T 1150 lotima board 010116

mrjimbo64

I tried adding a slave drive to my emachine and an additional stick of ram.
The problem now is it is not reconizing any of my drives. I took the additional stick of memory out & the additional drive thinking that this was the problem, but it did not reslove the issue.Does anyone have info on where all the jumper & wires go on this board?? I can get the cpu fan to start up, but that's all.Any info on how to reslolve my issue would be much appreciated.
Mrjimbo.

edwin · Posted: Mon Aug 11, 2008 5:57 pm Post subject:

you may want to check the jumper settings on the drives, I suspect the new drive was not set as slave (the old one being master).

eMachine Lomita board info:
http://www.e4allupgraders.info/dir1/motherboard...t370/lomita.shtml
_________________
edwin/evasive

Do not assume anything

System error, strike any user to continue...