AMD engineering Sample 00

Don't ask how to over-clock.
Post Reply
red2000z28
New visitors - please read the rules.
Posts: 10
Joined: Sat Mar 18, 2006 7:37 pm

I just got a new motherboard, a DFI NF3 250-AL. I have an AMD 3400+ XP 64bit cpu that was recognized fine on my old board but for some reason it shows as an AMD engineering Sample 00 on this board. When I go into control panel, System, it shows that the CPU is only bing run at 800mhz. I have already checked for bios updates and there arne't any.
red2000z28
New visitors - please read the rules.
Posts: 10
Joined: Sat Mar 18, 2006 7:37 pm

ttt
edwin
The Hardware Archivist
Posts: 6286
Joined: Wed Mar 20, 2002 7:11 pm
Location: Netherlands
Contact:

email DFI tech support about this. You have made sure this board supports that CPU to begin with?
edwin/evasive

Do not assume anything

System error, strike any user to continue...
red2000z28
New visitors - please read the rules.
Posts: 10
Joined: Sat Mar 18, 2006 7:37 pm

Yes it supports the CPU. I have already emailed DFI, waiting on a response.
edwin
The Hardware Archivist
Posts: 6286
Joined: Wed Mar 20, 2002 7:11 pm
Location: Netherlands
Contact:

Let us know, if it takes them too long (more than 2 weeks) we'll fire a few emails there as well...
edwin/evasive

Do not assume anything

System error, strike any user to continue...
Denniss
BIOS Guru
Posts: 3153
Joined: Thu Mar 21, 2002 8:16 pm
Location: Near Hannover (CEBIT) Germany
Contact:

I've seen this behaviour several time on other forums, it seems the 3400+ is a C0 stepping and that's not implemented in all board because they are very rare.
red2000z28
New visitors - please read the rules.
Posts: 10
Joined: Sat Mar 18, 2006 7:37 pm

Still waiting on a reply from DFI. I installed the CPU in another DFI board and it does the same thing. In any other board that I have tried though, it recognizes it as the CPU it is.
Post Reply