Search found 12 matches
- Sat Sep 30, 2006 3:27 pm
- Forum: Where can I find a motherboard manual?
- Topic: Pandora Motherboard
- Replies: 2
- Views: 5738
Pandora Motherboard
I need a Manual for this motherboard. It's a K7 slot A board with 5 PCI slots. It has no ISA slots. It has three Sdram slots but only two recognise memory. The board was made by Asus and liceinsed to H.P. It runs a version of PhoenixBios 4.0 J2.0 Rel 2.0 The board runs with the Pand_200 upgrade but ...
- Mon Jul 24, 2006 10:34 pm
- Forum: My motherboard is dead
- Topic: H.P. Compaq Web site.
- Replies: 1
- Views: 2872
H.P. Compaq Web site.
I am working on several Compaq and H.P. Motherboards. Can anyone tell me how to find the Motherboard specifications, when you don't know for sure which H.P. computer it started out in? There is a lot of information on the support web sight but it is organized to go with the computer product #. Thank...
- Thu Jun 15, 2006 4:56 pm
- Forum: My motherboard is dead
- Topic: Asus K8N-DL Mother Board.
- Replies: 0
- Views: 2928
Asus K8N-DL Mother Board.
Good Morning All: I RMA'ed one of these Boards. The one that I got back has a short in the board. The reset Led on my Post Reader card stays on even with only one CPU and it's memory is installed. I have inspected the underside and all the slots with a magnifing glass. I cleaned and inspected all pi...
- Tue May 16, 2006 6:17 pm
- Forum: My motherboard is dead
- Topic: Jumper setting to use ATX P.S.U. with SY-5SSB Soyo M. B.
- Replies: 6
- Views: 6142
P.S.U. checks 0ut.
The Power supply runs another board and the P.O.ST. card gives the voltages an o.k. Iv'e tried to trace the starting pins with continuity but without a schematic it's hopeless.
Thanks,
B.K.
Thanks,
B.K.
- Tue May 09, 2006 5:28 pm
- Forum: My motherboard is dead
- Topic: Jumper setting to use ATX P.S.U. with SY-5SSB Soyo M. B.
- Replies: 6
- Views: 6142
Good Morning Denniss:
I tried that. One of the pins is ground the other has a high resistence ground. Something is keeping the PSU from starting becaus when I short the green wire it runs normal.
Thanks,
B.K.
Thanks,
B.K.
- Mon May 08, 2006 11:27 pm
- Forum: My motherboard is dead
- Topic: Jumper setting to use ATX P.S.U. with SY-5SSB Soyo M. B.
- Replies: 6
- Views: 6142
ATX P.S.U. with SY-5SSB
Thanks Denniss:
I tried that,also,checked the P.S.U. It's O. K. I don't think that Soyo is going to answer for a M.B. this old. I tried them. I think that my best bet is that someone on some forum will remember.
B.K.
I tried that,also,checked the P.S.U. It's O. K. I don't think that Soyo is going to answer for a M.B. this old. I tried them. I think that my best bet is that someone on some forum will remember.
B.K.
- Sat May 06, 2006 7:18 pm
- Forum: My motherboard is dead
- Topic: Jumper setting to use ATX P.S.U. with SY-5SSB Soyo M. B.
- Replies: 6
- Views: 6142
Jumper setting to use ATX P.S.U. with SY-5SSB Soyo M. B.
I can't find it on this board. It has both sets of connectors. The User Manual has no setting for it.
Thanks,
B.K.
Thanks,
B.K.
- Sat Apr 15, 2006 9:41 pm
- Forum: My motherboard is dead
- Topic: Can't complete P.O.S.T. K8N-DL
- Replies: 1
- Views: 2729
Can't complete P.O.S.T. K8N-DL
I was trying to install the nvida system drivers from the system C.D. when the computer died.The Power Supply checks O.K. Runs a different computer. The memory checks o.K. in another computer. I am still looking for another board in which to check the Nvida GeForce 6600. My Micro2000 P.O.S.T. card i...
- Fri Dec 30, 2005 8:09 pm
- Forum: My motherboard is dead
- Topic: Crisis recovery disk for Pavilion 8770C
- Replies: 4
- Views: 4095
crisis recovery disk
Its a big site. I have been on it. Can't say that what I need isn't there but I can't find it.
Thanks,
B.K.
Thanks,
B.K.
- Thu Dec 29, 2005 7:36 pm
- Forum: My motherboard is dead
- Topic: Uniflash with BIOS savior RD1-M2.
- Replies: 0
- Views: 2142
Uniflash with BIOS savior RD1-M2.
I can't copy an image to the chip on this 2 meg savior. Does uniflash 1.40 need a batch file?
Thanks,
Thanks,
- Thu Dec 29, 2005 7:27 pm
- Forum: My motherboard is dead
- Topic: Crisis recovery disk for Pavilion 8770C
- Replies: 4
- Views: 4095
Crisis recovery disk for Pavilion 8770C
Where can I find a crisis recovery diskete, or the directions to make one?
Thanks.
Thanks.