Hello
Well my problem is my computer will not start up after in froze and could only be shut off threw the kill switch!
After i turned it back on it told me it needs the start cd to start up again!
That should normaly not be and for that reason i checked my Bios (version Phoenix 3.0) and it told me that my Master harddrive was from this moment on a Slave drive!
Since that is i do know why my computer will not start up again!
Is there a way to switch my harddrive from slave to master in Bios???
I did try to switch that my computer boots first from the Harddrive but since i have now 2 Slave drives and they are mixed up for which one is really the first (Master became #2 Slave drive and my Slave drive is #1 of my slave drives)!
would be perfect if there is a way without loseing data since that is the last way out!
thanks for all the help i get!
Computer will not start up!
The hard-drive itself has jumpers to determine whether it be a slave or
master...
If your system was OK until it locked up, then i'm assuming you don't
also have another drive like a CD/DVD rom, or another hard-drive
connected onto the same ribbon/cable as the one with the operating
system on it...
If that's the case, then the one single drive on the IDE 1 cable shouldn't
really matter wether it's set to master or slave...
master...
If your system was OK until it locked up, then i'm assuming you don't
also have another drive like a CD/DVD rom, or another hard-drive
connected onto the same ribbon/cable as the one with the operating
system on it...
If that's the case, then the one single drive on the IDE 1 cable shouldn't
really matter wether it's set to master or slave...