Emachines T 1150 lotima board 010116

BIOS Questions that don't belong in the other forums. Read them!
Post Reply
mrjimbo64
New visitors - please read the rules.
Posts: 1
Joined: Sun Aug 10, 2008 12:55 am

Sun Aug 10, 2008 1:02 am

I tried adding a slave drive to my emachine and an additional stick of ram.
The problem now is it is not reconizing any of my drives. I took the additional stick of memory out & the additional drive thinking that this was the problem, but it did not reslove the issue.Does anyone have info on where all the jumper & wires go on this board?? I can get the cpu fan to start up, but that's all.Any info on how to reslolve my issue would be much appreciated.
Mrjimbo.
edwin
The Hardware Archivist
Posts: 6231
Joined: Wed Mar 20, 2002 7:11 pm
Location: Netherlands
Contact:

Mon Aug 11, 2008 7:57 pm

you may want to check the jumper settings on the drives, I suspect the new drive was not set as slave (the old one being master).

eMachine Lomita board info:
http://www.e4allupgraders.info/dir1/mot ... mita.shtml
edwin/evasive

Do not assume anything

System error, strike any user to continue...
Post Reply