I tried adding a slave drive to my emachine and an additional stick of ram.
The problem now is it is not reconizing any of my drives. I took the additional stick of memory out & the additional drive thinking that this was the problem, but it did not reslove the issue.Does anyone have info on where all the jumper & wires go on this board?? I can get the cpu fan to start up, but that's all.Any info on how to reslolve my issue would be much appreciated.
Mrjimbo.
Emachines T 1150 lotima board 010116
-
- The Hardware Archivist
- Posts: 6286
- Joined: Wed Mar 20, 2002 7:11 pm
- Location: Netherlands
- Contact:
you may want to check the jumper settings on the drives, I suspect the new drive was not set as slave (the old one being master).
eMachine Lomita board info:
http://www.e4allupgraders.info/dir1/mot ... mita.shtml
eMachine Lomita board info:
http://www.e4allupgraders.info/dir1/mot ... mita.shtml
edwin/evasive
Do not assume anything
System error, strike any user to continue...
Do not assume anything
System error, strike any user to continue...