How To Delete Ontrack DDO From My Seagate Drive

BIOS Questions that don't belong in the other forums. Read them!
Post Reply
Bedford
New visitors - please read the rules.
Posts: 15
Joined: Tue Jan 07, 2003 4:02 pm

I used the maintenance option to remove the DDO but the BIOS was still showing the drive as 32gb, i removed the jumper limiting the drive but still no joy.

any help?
soupy
Absentee administrator
Posts: 1086
Joined: Thu Mar 21, 2002 1:06 am
Location: Ontario, Canada
Contact:

Try a Win98 boot floppy, then FDISK /MBR
Flash your BIOS at your own risk.
Bedford
New visitors - please read the rules.
Posts: 15
Joined: Tue Jan 07, 2003 4:02 pm

i've tried that and it still doesnt work

ive formated C:

ive used FDISK /MBR and SYS C:

when in DOS the drive shows as 80gb but the bios shows it as 32gb still

i try to install win2k but get INACCESSIBLE_BOOT_DEVICE error
soupy
Absentee administrator
Posts: 1086
Joined: Thu Mar 21, 2002 1:06 am
Location: Ontario, Canada
Contact:

I'm assuming your BIOS actually does support 32GB+ ?
Flash your BIOS at your own risk.
NickS
BIOS Bodhisattva
Posts: 3145
Joined: Fri May 03, 2002 10:34 am
Location: Thames Valley, UK

soupy wrote:I'm assuming your BIOS actually does support 32GB+ ?
I should hope so (Can't find an icon for "smirk") as I used Rainbow's utility. My suggestion was that the Seagate OnTrack [edit] (sorry, Disk Wizard)[/edit] disk manager utility has told the drive firmware to report 32GB (like IBM's version does for the Deskstar - Alistair.Kirk had that issue) but I haven't used it so I don't know whether it does and whether it can be reverted. There was someone who posted with a similar problem who found he could get his (Maxtor?) drive reset temporarily using the IBM tool but that it would not stay set. In the end he sent it back and got it replaced under warranty.

@bedford: Look for a copy of ideid.exe and see what it reports.

Also: Zap.exe Zeros first 128 sectors of the HDD - this should wipe out disc overlay boot sector software, but it will not reset capacity reporting if done by drive firmware.
NickS
BIOS Bodhisattva
Posts: 3145
Joined: Fri May 03, 2002 10:34 am
Location: Thames Valley, UK

From the horse's mouth:
Here is the procedure for checking or setting the reported drive size:
o Load DiscWizard Starter Edition
o Select "Utilities"
o Select "Set Hard Drive Size"
o Select the correct drive ( if more than one drive installed)
o If the "Current Maximum LBA/CYL" is not equal to the "Native Maximum
LBA/CYL" values, change it to the value in the Native Maximum LBA/CYL
number.
This should force the drive to report the correct size to the BIOS.

If you are still unable to read the full capacity of the drive, use
DiscWizard Starter Edition to run a Zero Fill on the drive. This will
write through the MBR with zero's to remove any remnants of the DDO.

Danny M.
Seagate Technical Support
I've put this in the "collected wisdom".
Post Reply