I want to install a Maxtor 91021U2 harddrive into an MEC PH50705C motherboard computer . I suppose that is possible , but the IDE connectors on the motherboard have 40 pins and not 39 pins and the IDE cables I have have 39 holes for pins............
........er , yes , I've been shopping and found what I am looking for
older IDE cable
-
- BIOS Guru
- Posts: 3153
- Joined: Thu Mar 21, 2002 8:16 pm
- Location: Near Hannover (CEBIT) Germany
- Contact:
There are always 40 pins on connector and cable but at least one is not connected/used and some manufacturers leave this pin/hole out to prevent mounting the cable in the wrong direction. If you have 40 pins but only 39 holes then you need a new cable with 40 holes
...or if brave/foolish you bend the extra pin backwards and forwards until it snaps off. (A hand wire-wrapping tool is useful for this but there do not seem to be many wire-wrapping tools around these days.)Denniss wrote:There are always 40 pins on connector and cable but at least one is not connected/used and some manufacturers leave this pin/hole out to prevent mounting the cable in the wrong direction. If you have 40 pins but only 39 holes then you need a new cable with 40 holes
Tested patched BIOSes. Untested patched BIOSes.
Emails *will* be ignored unless the subject line starts "Wim's BIOS forum"
Emails *will* be ignored unless the subject line starts "Wim's BIOS forum"
Or just push the cable hard enough into the connector (do not crack the board). It works at least with some cables where the hole is present bud covered with thin plastic on top.
Patched and tested BIOSes are at http://wims.rainbow-software.org
UniFlash - Flash anything anywhere
UniFlash - Flash anything anywhere