VIA KT6V - System Performance, Fast, Super, Ultra

BIOS Questions that don't belong in the other forums. Read them!
Post Reply
ElPeque
New visitors - please read the rules.
Posts: 4
Joined: Wed Sep 21, 2005 7:04 am

this is a setting in the memory configuration tab in the BIOS setup.

I was using an ATI9600xt in my sysyem with that setting in "ultra", but after changing my card to a nV GF 6600GT, the system locks in one of the last stages of the setup process, just before i should be able to enter setup again. "The message: Run Flash Recovery" is displayed.

I had to reset the settings with the jumper to be able to enter the bios setup.

After resetting several times, due to trial and error i was able to identify the setting that triggered the error message. If i left it with "fast", then it boots correctly.

Why does it work with the 9600 but not with the 6600GT? Does this mean the system is unstable? If i leave it at "Fast" instead of Ultra does it represent a considerable performance impact?

Thanks a lot in advance.

Peque
Denniss
BIOS Guru
Posts: 3153
Joined: Thu Mar 21, 2002 8:16 pm
Location: Near Hannover (CEBIT) Germany
Contact:

Either chipset or memory timings are affected by such settings. Using a new graphics card requiring more power may result in a slightly underpowered 3.3/5/12V line and this setting becomes unstable.
Post Reply