
Recently my 10gb hard disk crash, so I purchase 40gb seagate hard-disk (as 10 or 20gb hdd is not available anymore) and since my motherboard was not able to detect the new hard disk, I download "Awdf773.exe" and "B687v12.bin" from www.procomp.com.tw and flash my motherboard bios. After flashing the bios, it is all the same(It doesn't recognize or detect the new drive) So what is to be done so that the new hard disk is detected by auto-detection?
Data of my motherboard is as below:
B687ZX BIOS VER:1.2
AWARD PNP BIOS EX V1.0A
03/02/1999-i440ZX-ALI513-2A69KPNDC-00
And after flashing, the above parameters changes to:
B687 BIOS VER:1.2
AWARD PNP BIOS EX V1.0A
02/12/1999-i440BX-ALI513-2A69KPNDC-00
is this ok?
While flashing, is autoexec.bat and config.sys are required? If required what commands are needed?
Will be happy if someone can send me email me the required .bin file as
attachment with instructions.
Thanks
Thangpao