pROCOMP BS61B MOTHER BOARD BIOS

BIOS update, EIDE card, or overlay software? (FAQ Hard disk recognition)
Denniss
BIOS Guru
Posts: 3153
Joined: Thu Mar 21, 2002 8:16 pm
Location: Near Hannover (CEBIT) Germany
Contact:

Use Uniflash - better than Award flashprog especially on old boards.
http://www.uniflash.org/

If you are flashing from a floppy disk then make sure the disk is error free. Do a fresh and full format to find possible errors.
blackknight11
New visitors - please read the rules.
Posts: 10
Joined: Wed Feb 13, 2008 11:39 pm

I've solved the problem.
I recover the mother by doing hot-flashing.
The origin of the problem was the bios files posted by edwin. The bad flash (with this wrong files) did that the Award Bootblock will begin the recovery process, but it don't recognize the floppy drive and then it shows the message "System Halt". In these cases it would try to use an ISA floppy controller or a multi I/O card.

Does somebody know where downloading the correct bios files for this mother? Thanks.
Post Reply