Search found 4 matches
- Sat May 21, 2005 11:49 pm
- Forum: My hard drive isn't recognized
- Topic: My Seagate ST380021A hard drive not recognized
- Replies: 7
- Views: 6570
The controller change was bad advice. The hard drive’s are set for cable select and the connectors are Black on the Seagate, Blue on the Maxtor and White on the Western Digital. I ran A Seagate utility but because the BIOS setup doesn’t detect the drive it doesn’t see it (Unknown Device) and no I do...
- Sat May 21, 2005 8:54 pm
- Forum: My hard drive isn't recognized
- Topic: My Seagate ST380021A hard drive not recognized
- Replies: 7
- Views: 6570
Been there did that....
Ok...But when I attach the drive and the BIOS is configured for Auto check on for IDE detection, and It comes back with Unknown Drive. If I add it to a working system (PC) both drives say Unknown Drive. With out this Seagate drive it says the other drive is a Hard Drive and it shows the drive Mfg. a...
- Wed May 18, 2005 4:09 pm
- Forum: My hard drive isn't recognized
- Topic: My Seagate ST380021A hard drive not recognized
- Replies: 7
- Views: 6570
My Seagate ST380021A hard drive not recognized
I replaced the Controller board with the same Firmware level 3.19 and when I connect it to the IDE cable (the jumper is set on Cable Select) it is not recognized. I’ve connected it to the 1st and 2nd connector. When connected all other devices attached to the IDE controller (both Primary and Seconda...