Ok so i bought some new good spec ram. i switch them out but they still read timings and settings same as old ram so i go into bios to see if i can change the settings.
my bios didnt seem to have that feature so i looked for a bios update on my manufacter site. the date was 8 months ahead of what i had i used the winflash utility i backed up my old bios first.
i installed the new one but when my pc rebooted it just beeped once over and over.
so i figure maybe theres a settings conflict i couldnt find a jumper by the battery so i just pulled the battery.
the pc booted up i go into bios and look bios is an outdated version. soon as i exit bios it beeped agian with no setting changed. i pull the battery again and i get it too boot just didnt go into bios i load my old bios same thing.
now if i go into bios it will beep and i will have to pull my battery.
i got an error on first boot after i pull battery. please reset cpu freq in cmos setup.
Now sometimes when i reset it beeps and i dont dare go into bios agian any ideas how to fix the damage ive done?
some of my bios info
BIOS Date: 04/27/07
BIOS Type: Phoenix - Award WorkstationBIOS
BIOS ID: 04/27/2007-MCP61M-AM-6A61KE11C
OEM Sign-On: This BIOS is exclusively for Acer only (R01-B4)
Chipset: AMD 1100 rev 0
Superio: Unknown
OS: WinXP SP2
CPU: Unknown
BIOS ROM In Socket: Yes
BIOS ROM Size: 512K
bios update now pc fails to boot alot
Its an Acer Aspire 380. i got it from the acer.ca website. i just tried plugging my old ram back in and now my bios seems to work fine no errors.
The ram i bought is ocz gold edition pc2 6400 1gb ddr2 5-5-5-12 800mhz
the old ram i got has a 400mhz max.
So maybe this is a ram compatibility and not a motherboard dead topic.
The ram i bought is ocz gold edition pc2 6400 1gb ddr2 5-5-5-12 800mhz
the old ram i got has a 400mhz max.
So maybe this is a ram compatibility and not a motherboard dead topic.
-
- The Hardware Archivist
- Posts: 6286
- Joined: Wed Mar 20, 2002 7:11 pm
- Location: Netherlands
- Contact:
Yep that is a memory problem.
http://configurator.ocztechnology.com/r ... elid=64887
is what you should be using according to ocz.
http://configurator.ocztechnology.com/r ... elid=64887
is what you should be using according to ocz.
edwin/evasive
Do not assume anything
System error, strike any user to continue...
Do not assume anything
System error, strike any user to continue...