My M520 is dead and I'm so very witty...

Hot-swapping and Boot-Block flash & Boot block flash and floppy support
Post Reply
jallen
New visitors - please read the rules.
Posts: 2
Joined: Thu Aug 01, 2002 7:30 pm

:evil: Ho kay , if were all stitting comfortablyi shall begin :

I'm running a small network , for my own fun , and i add terminal as often as i can. My new'est one is a M-520 mother board and thats it. I have enuff parts riped from terminal that died on me to make a new one. SO this is what i have added to " try " and get her up and running

BIOS:
AWARD PCI/PNP 586
S/N 05065283 V

Processor:
IBM 6x86 P166+
(IMB26 6x82-2v7P166GE)
( 133MHz/3.5v )

However , when i give her some power , she just sits there. Hard Drive light stays on and PC spk just beep on , off , on off. Does any one know what is wrong?? Me thinks its one of two things

ONE :
Shes does like the Prosessor so wont work for me.
or
TWO:
The BIOS / CMOS or jumper setting are screwd.
....

..........help??
Rainbow
The UniFlasher
Posts: 3122
Joined: Wed Mar 20, 2002 4:16 pm
Location: Slovakia
Contact:

Reseat the memory.
Patched and tested BIOSes are at http://wims.rainbow-software.org
UniFlash - Flash anything anywhere
jallen
New visitors - please read the rules.
Posts: 2
Joined: Thu Aug 01, 2002 7:30 pm

how buddy? :D
NickS
BIOS Bodhisattva
Posts: 3145
Joined: Fri May 03, 2002 10:34 am
Location: Thames Valley, UK

Reseat=take out, put back in carefully ensuring it is pressed fully into place.
Disconnect all drives and see if that helps.
Tested patched BIOSes. Untested patched BIOSes.
Emails *will* be ignored unless the subject line starts "Wim's BIOS forum"
Post Reply