No POST, no beeps.

Hot-swapping and Boot-Block flash & Boot block flash and floppy support
Post Reply
RandomZero
New visitors - please read the rules.
Posts: 4
Joined: Tue Feb 10, 2009 6:41 am

I have a PC that I'm using as storage and a while ago it stopped booting.

When I turn it on, everything sounds like it's booting (HDD/CD rom spins, lights are all on, ect) but it just sits at a black screen.

There are no beeps or anything so I can't tell what's wrong.

Is there a way to diagnose this problem without swapping out each and every component? I've tried booting it with just barebone hardware, but it still won't boot, and I don't have replacements for any of it.
miki02131
New visitors - please read the rules.
Posts: 12
Joined: Fri Jan 16, 2009 2:32 am

You need a new graphic card.

Thanks,

Miki.
RandomZero
New visitors - please read the rules.
Posts: 4
Joined: Tue Feb 10, 2009 6:41 am

:(

Not the cause unfortunately.
I just tried the vid card in this PC and it boots fine.
Denniss
BIOS Guru
Posts: 3153
Joined: Thu Mar 21, 2002 8:16 pm
Location: Near Hannover (CEBIT) Germany
Contact:

Try to clear CMOS first.

If a system doesn't boot but also doesn't beep may be the cause of a major hardware failure (board, ram or CPU). AFAIR with all three components working there should be beeps.
RandomZero
New visitors - please read the rules.
Posts: 4
Joined: Tue Feb 10, 2009 6:41 am

what if the system just doesn't have any speakers?
hypermog
New visitors - please read the rules.
Posts: 6
Joined: Wed Feb 18, 2009 2:21 am

I had a computer that was just like this, did not output a video signal unless you cold booted and waited an entire 30 minutes, at which point it would turn on and display the boot block recovery message. You had to have it connected to the monitor the whole time as well or it wouldn't work. After I reflashed the BIOS, it was perfect.

See this post for more info. http://www.wimsbios.com/phpBB2/topic8350-555.html#52109
Denniss
BIOS Guru
Posts: 3153
Joined: Thu Mar 21, 2002 8:16 pm
Location: Near Hannover (CEBIT) Germany
Contact:

RandomZero wrote:what if the system just doesn't have any speakers?
Connect speakers to be sure it's not beeping, trying to tell you something about the problems it has.
Post Reply