Bios Update
I am trying to update my ecs p4s5mg/gl+ rev7.0 ami bios so i can up clock speed to 133. I went to ecs downloaded flash utility and update to floppy when i boot up type dir i have no bin file what am i doing wrong? All that is showing ia a command-autoexe bat-e020118s rom-aminf332 exe.
Thanks for your reply i ran the flash exe and rom file a page came up i dont understand. A: autodecting & programing flash rom
B: to force boot blocking programming
C: load bios cmos default values without warning user about configuration.
D: clear passwords during loading cmos deafults
E: clear cmos after programming is done
G: GPNV data area reserving
I :identification bios file is right for this system or not
N: to force NVRAM programming
O: flash functions call from bios file
P: to make [ security ] item visible
R: force reboot after programming is done
S: to save flash rom data into file and quit
T: retry if programmimg fails
U: to update utilitys modules checksum
V: verify bios checksum
X: enter utilitys user interface without system checking
OPTIONS : Disable flags
OPTIONS
B C D E G I N O R U
A:/>
B: to force boot blocking programming
C: load bios cmos default values without warning user about configuration.
D: clear passwords during loading cmos deafults
E: clear cmos after programming is done
G: GPNV data area reserving
I :identification bios file is right for this system or not
N: to force NVRAM programming
O: flash functions call from bios file
P: to make [ security ] item visible
R: force reboot after programming is done
S: to save flash rom data into file and quit
T: retry if programmimg fails
U: to update utilitys modules checksum
V: verify bios checksum
X: enter utilitys user interface without system checking
OPTIONS : Disable flags
OPTIONS
B C D E G I N O R U
A:/>