RC410-M ufter update BIOS dead

Hot-swapping and Boot-Block flash & Boot block flash and floppy support
Post Reply
NetWolF
New visitors - please read the rules.
Posts: 1
Joined: Fri Apr 04, 2008 2:59 am

Hi, I am new here.

I am having problem with my ECS RC410-M mboard.

I need bios update.

After flashing it I got the message flash was successfull. I then restart my computer and it would not boot, single short beep and this message:
....
Press Shift F10 to configure.......

Message disappears after few seconds and only black screen on monitor.

This is what I have tried so far:
(With power OFF, power unplug)
-Remove battery for 1 hour, retry, still fail.
-Position JBAT1 to 2-3 for few minutes, put back JBAT1 to 1-2, retry, still fail.

Thank you for your attention and time to read this post.
KnightNemesis
New visitors - please read the rules.
Posts: 5
Joined: Sun Jul 06, 2008 9:57 am

Your Using a ECS RC410-M OEM Was basically Made By ECS For Gateway's Low Cost version Emacihines PC's
The Asterope GL Is not the same Mobo After i researced quite a Bit But you need to restore your Bios
try this site Thats where i found all the RC410-M Drivers
www.e4upgraders.com
Or try a google search for Emachines Upgraders
This is the only availble site online for the correct drivers to this MoBo
How do i know you May be wondering???
My Wife recently bought an Emachines W3619 Series PC And low an behold Exact Same MB as you Have Same one I Have Although I Bought my MB New from a Supplier its the exact same MB as Emajunk Used in Hers
edwin
The Hardware Archivist
Posts: 6286
Joined: Wed Mar 20, 2002 7:11 pm
Location: Netherlands
Contact:

http://www.e4allupgraders.info/ is what you're looking for
edwin/evasive

Do not assume anything

System error, strike any user to continue...
Post Reply