"Intel Screen" at bootup stays on for 20s after re

APM/ACPI BIOS questions
Post Reply
Trig
New visitors - please read the rules.
Posts: 2
Joined: Sun Dec 31, 2006 11:35 pm

My harddrive was dying so I reformatted, reinstalled Win xp, etc. Everything works fine except when I boot up or turn computer on from hibernate I get the intel screen up for about 20 seconds first and it doesn't sound like it's doing anything. Then it checks the drives and boots normally. If I hit F2 to enter setup it says entering setup for the same amount of time.
I have updated my bios. I have played with cmos setting (disabled quiet boot, changed order of drives for boot up, etc) to no avail.
Bios is: PT84510A.86A.0012.P02
Motherboard: Intel D845BG
Pentium 4, 1.60GHz, 512MB RAM
Win XP home, sp2
New this time round in startup: D-link wireless (ran wireless before but not with d-link in startup): AIRGCFG and WZCSLDR2.
So why is it doing this? What is the fix? I understand quite a bit but not too good at cmos or command prompts. Please give detail or link to detail if you have steps to answer.
Thanks!
Trig
edwin
The Hardware Archivist
Posts: 6286
Joined: Wed Mar 20, 2002 7:11 pm
Location: Netherlands
Contact:

My harddrive was dying so I reformatted, reinstalled Win xp, etc.
You have replaced that harddisk?

If so, is the new drive a Western Digital?

If so, did you jumper it for Master?

If so, jumper it for single drive (no jumper or on just one pin).
edwin/evasive

Do not assume anything

System error, strike any user to continue...
Trig
New visitors - please read the rules.
Posts: 2
Joined: Sun Dec 31, 2006 11:35 pm

Harddrive is Maxtor 6L080p0
I jumpered it for master (took a guess and then went to the website and found I was right). It's on the far left now, anyway.
Post Reply