BIOS Updates forum

You will not have much luck programming the cat28F010 with out an external power supply with that programmer. You can program the Intel N82802AB8 with it. it is a firmware hub and it is in the menu you just put it in the firmware hub LPC socket and set up the programmer accordingly. you should alway...

Yes to program the CAT28F010 select the 28F010 then click the ? for device ID It must return Manufacture Code 0x31 CATALYST Device Code 0xB4 CAT28F010 I it does not then you may the have switch setting jumpers wrong, recheck and try again. To program 28F001BX-T select from the menu Flash 28Fxxx > 28...

The Willem is a good programmer, I etched and built both the Ath 3.1s Single sided Version and the 4.1 version myself.

CAT28F010 IS 128X8K Block so use the xxxS.bin

software can not pull anything anywhere. they can just control some switches, that's all. they will trigger the onboard logic, right. if Vpp is left unconnected (e.g. no jumper on a valid motherboard layout) it will be pulled exactly nowhere since it is floating. You had better check that out Yes s...

The m520 that i owned had a design flaw when jp5 was set to 12v for VPP the VCC line was at 12v I even checked it with a multimeter after i burned out 3 flashroms on it. The original MX28F1000PX and 2 intel 28f010. The flash ROM would get so hot you could fry eggs on it and that was from new. that i...

hi cp thanks for the datasheet info. i put the jumper back at 12v jp5.the chip should be coming in a few days thanks again for all your help. have a nice day. cee710 That is a 5 Volt VCC flash Rom he is sending you, It only uses 12 Volt VPP for erase and Flash. Set the jumper to 5 Volts VCC or you ...