Emachines T 1150 lotima board 010116
Posted: Sun Aug 10, 2008 1:02 am
I tried adding a slave drive to my emachine and an additional stick of ram.
The problem now is it is not reconizing any of my drives. I took the additional stick of memory out & the additional drive thinking that this was the problem, but it did not reslove the issue.Does anyone have info on where all the jumper & wires go on this board?? I can get the cpu fan to start up, but that's all.Any info on how to reslolve my issue would be much appreciated.
Mrjimbo.
The problem now is it is not reconizing any of my drives. I took the additional stick of memory out & the additional drive thinking that this was the problem, but it did not reslove the issue.Does anyone have info on where all the jumper & wires go on this board?? I can get the cpu fan to start up, but that's all.Any info on how to reslolve my issue would be much appreciated.
Mrjimbo.