Page 1 of 1
Help me!!!
Posted: Fri May 09, 2003 12:14 am
by claudio
I can't connect a digital camera to my pc via usb. My mother board was made in 1997.It supports USB connection but when I turn on the camera no plug and play message appears on the screen to detect and install the drivers for the camera..... could it be a problem about the compatibility between my old motherboard bios and a new USB tecnology maybe requested by my camera to be connected to pc? Please help me....I want to find a solution!! Thanks very much
Claudio
Posted: Fri May 09, 2003 12:26 am
by ajzchips
Is USB enabled in BIOS? Please tell us what motherboard you have.
Help me!
Posted: Fri May 09, 2003 12:36 am
by claudio
I haven't any option in my bios to enable USB.My motherboard is Pentium P5I430TX Titanium IB
Posted: Fri May 09, 2003 1:02 am
by ajzchips
Can you see the USB entries in the Windows Device Manager?
Posted: Fri May 09, 2003 1:57 pm
by KachiWachi
What camera are you trying to install? Did you follow the manufacturers directions for installing it? Usually you have to load their software first, then go through a setup processs that will properly install and test the camera.
If your board has built-in USB ports, there has to be BIOS options for them.
Also please post motherboard BIOS ID string.
