IBM Travelstar IC25N010ATDA04 for notebook Datajet 862
Posted: Thu Jul 25, 2002 11:19 am
Hi all,
I try to change from 1.4Go dead disk to this new IBM 10Go on a 1997 notebook.
The HDD has 16383 Cyl, 16 Heads, 63 sect/track: these values are shown in bios HDD settings, but total capacity is set a 8Go: after partition can be created, but any Microsoft boot disks stop.
I check the bios: SystemSoft Bios for UMC8890 version 1.01
1.00.1.00 04-09-97 20BW
I found no Datajet or SystemSoft support/upgrade on the web.
Can someone tell me how to configure this hard drive to be accessible ?
I've got other parameters possible in drive setting in Bios: Multiple sector mode, landing zone, write precomp.
(even if its capacity has to be truncated, 8Go would be enough)
Thanks very much for your help
Eric.
I try to change from 1.4Go dead disk to this new IBM 10Go on a 1997 notebook.
The HDD has 16383 Cyl, 16 Heads, 63 sect/track: these values are shown in bios HDD settings, but total capacity is set a 8Go: after partition can be created, but any Microsoft boot disks stop.
I check the bios: SystemSoft Bios for UMC8890 version 1.01
1.00.1.00 04-09-97 20BW
I found no Datajet or SystemSoft support/upgrade on the web.
Can someone tell me how to configure this hard drive to be accessible ?
I've got other parameters possible in drive setting in Bios: Multiple sector mode, landing zone, write precomp.
(even if its capacity has to be truncated, 8Go would be enough)
Thanks very much for your help
Eric.