Page 1 of 1
20GB: 62-0103-001131-00101111-071595-SiS730S-M810LR7-H
Posted: Sun Apr 13, 2003 2:08 am
by Monoxide
20GB Western Digital limiting my space to 8.4GB
Bios Date: 01/03/2003 S
Bios Id: 62-0103-001131-00101111-071595-SiS730S-M810LR7-H
AmiBios Version 1.21.06
Not much time in between the date there, but i havent partitioned the drive yet would it be more logical to just use drive overlay software and if so do i have to use one made for my hdd or are they all universal?
Posted: Sun Apr 13, 2003 5:49 am
by ajzchips
A BIOS that recent will support practically ANY hard disk drive. Make sure you don't have any 8.4GB-limiting jumper set on the HDD.
Posted: Sun Apr 13, 2003 12:06 pm
by Rainbow
And make sure that MODE is set to LBA.
Posted: Mon Apr 14, 2003 7:31 am
by Monoxide
checked for jumpers all it had were for the Lan Led,and the one for CMOS reset and i checked the lba it was turned on, afraid that its dead as i havnt even been able to access the drive yet
Posted: Mon Apr 14, 2003 1:08 pm
by Denniss
Is the drive 1)detected as 8.4GB or 2) as 20GB and having only 8.4GB space ?
1) > Remove capacity limitation jumper on HDD
2) > Repartition your drive to full 20GB
http://radel.inet.net.nz/m810lmr.html
Posted: Mon Apr 14, 2003 8:20 pm
by Monoxide
First in bios my drive is listed as 8455MB,I just took the hdd out and took a look at it didnt see any other jumpers other than the master,slave,cable select,a jumper that dosent say anything and one thats says pm2
Posted: Mon Apr 14, 2003 11:30 pm
by Denniss
http://www.westerndigital.com/
Enter the model numer o your HDD into the search option and then have a closer look onto the HDD jumpers - seems it's jumpered to 8GB
