Page 1 of 1
80GB: Microstar (MSI) MS6119
Posted: Fri Jun 13, 2003 7:57 pm
by marvin51796
I am trying to install a 80G WD hard drive, and i have it patched up to the 2.a version that supports drives over 64G and has a date of 08-21-2000 on it. The problems is that once i connect this drive as primary or slave the system boots , sees the drive and then locks up after it goes thru the disk search.
I have no idea of what to do next and could use any help or ideas.
Posted: Fri Jun 13, 2003 9:07 pm
by Rainbow
Do you have drive jumpers set properly? If the drive is the only device on the cable, it must be configured as single, not master.
Posted: Fri Jun 13, 2003 10:08 pm
by marvin51796
Yes i have the jumpers set right, i have set it as the primary master, i have set it up as the primary slave with a 4g HD as the primary master. I have chosen the cable select setting....everything that the book has said i have done..
Posted: Fri Jun 13, 2003 10:42 pm
by ajzchips
Try to set it up manually in BIOS, rather than having it autodetected.
Finally, thnxs
Posted: Mon Jun 16, 2003 3:12 pm
by marvin51796
Well i was able to get the bios tricked into seeing the HD, and once it saw it I was able to load the software that came with it and XP saw it then.
Thanks to everyone for all the help i was so lost.
