Page 1 of 1
120GB: 10/08/1998-I440BX-ITE867-2A69KV31C-00
Posted: Wed Aug 13, 2003 2:50 pm
by tonvandevorst
I installed a new WD HDD in my pentium II PC but the disk was not recognized. How do I proceed? My BIOS details are as follows:
BIOS Type: Award
BIOS Date: 10/08/98
BIOS ID String: 10/08/1998-I440BX-ITE867-2A69KV31C-00
OEM Signon: BIOS-I-2M (81008)
Chipset: INTEL 440BX/ZX REV 2
Super I/O: ITE 8671 REV 1 FOUND AT PORT 279H
Thanks
Ton
Posted: Thu Aug 14, 2003 1:55 am
by edwin
Check board surface for 35-8xxx-xx number and reply with that.
Posted: Fri Aug 15, 2003 8:33 am
by tonvandevorst
The number on the motherboard is: 35 8839 01.
Thanks
Ton
Posted: Sat Aug 16, 2003 6:17 pm
by edwin
BXA839D ATX board, please verify this is your board:
Posted: Sun Aug 17, 2003 10:33 pm
by tonvandevorst
Hello Edwin,
The board looks very much the same, where could I find the number you mention. The label on the BIOS chip shows pci/pnp 686 144949918. Is this helpfull?
Thanks a lot your help is very welcome after three weeks hobbying.
Ton
Posted: Sun Aug 17, 2003 11:13 pm
by edwin
With board held as shown in the picture, upper left corner. About 1.5mm high letters.
Posted: Tue Aug 19, 2003 4:55 pm
by tonvandevorst
Hello Edwin,
In the upper left corner I can only find the number You asked before: 35 8839 01. Could it be on the backside of the board?
Thanks
Ton
Posted: Tue Aug 19, 2003 11:57 pm
by edwin
No it is the BXA839D allright.
Now get this file:
http://www.pcpartner.com/bios_zip/p829-2m.zip
unpack, read the note.txt and flash the appropriate bios for your board depending on the clock gen IC.
Either one supports harddisks up to 128GB.
Posted: Fri Aug 22, 2003 1:12 am
by tonvandevorst
Hello Edwin,
Thanks,
This helped a lot, great
Ton
