Page 1 of 1
AMD engineering Sample 00
Posted: Sun Dec 24, 2006 5:56 pm
by red2000z28
I just got a new motherboard, a DFI NF3 250-AL. I have an AMD 3400+ XP 64bit cpu that was recognized fine on my old board but for some reason it shows as an AMD engineering Sample 00 on this board. When I go into control panel, System, it shows that the CPU is only bing run at 800mhz. I have already checked for bios updates and there arne't any.
Posted: Wed Dec 27, 2006 12:37 pm
by red2000z28
ttt
Posted: Wed Dec 27, 2006 1:29 pm
by edwin
email DFI tech support about this. You have made sure this board supports that CPU to begin with?
Posted: Wed Dec 27, 2006 9:08 pm
by red2000z28
Yes it supports the CPU. I have already emailed DFI, waiting on a response.
Posted: Thu Dec 28, 2006 12:32 am
by edwin
Let us know, if it takes them too long (more than 2 weeks) we'll fire a few emails there as well...
Posted: Thu Dec 28, 2006 1:15 am
by Denniss
I've seen this behaviour several time on other forums, it seems the 3400+ is a C0 stepping and that's not implemented in all board because they are very rare.
Posted: Mon Jan 08, 2007 9:31 am
by red2000z28
Still waiting on a reply from DFI. I installed the CPU in another DFI board and it does the same thing. In any other board that I have tried though, it recognizes it as the CPU it is.
