RC410-M ufter update BIOS dead
Posted: Fri Apr 04, 2008 3:41 am
Hi, I am new here.
I am having problem with my ECS RC410-M mboard.
I need bios update.
After flashing it I got the message flash was successfull. I then restart my computer and it would not boot, single short beep and this message:
....
Press Shift F10 to configure.......
Message disappears after few seconds and only black screen on monitor.
This is what I have tried so far:
(With power OFF, power unplug)
-Remove battery for 1 hour, retry, still fail.
-Position JBAT1 to 2-3 for few minutes, put back JBAT1 to 1-2, retry, still fail.
Thank you for your attention and time to read this post.
I am having problem with my ECS RC410-M mboard.
I need bios update.
After flashing it I got the message flash was successfull. I then restart my computer and it would not boot, single short beep and this message:
....
Press Shift F10 to configure.......
Message disappears after few seconds and only black screen on monitor.
This is what I have tried so far:
(With power OFF, power unplug)
-Remove battery for 1 hour, retry, still fail.
-Position JBAT1 to 2-3 for few minutes, put back JBAT1 to 1-2, retry, still fail.
Thank you for your attention and time to read this post.