No Post or Beeps
Posted: Tue Sep 22, 2009 9:18 pm
Hi to 1 & all,
MB-MS-6775 ver1.00/AMIBIOS-686-1999 SH44 2557
I seem to have a problem similar to a lot of others ie black screen, all fans & drives working etc mine came about after upgrading my agp graphics, the HD 2400 pro 512 sapphire was stuttering when i was playing 3D games so i followed the manuals instructions to try & improve system performance! the changes made were as follow: set internal cache to enabled/set bios cacheable to enabled/set 32k shadow to enabled/set fast command to ultra/set fast R2R turnaround to enabled/set agp to fast write enabled & the aperture to 256 so far so good! I then changed the graphics from pci to agp & there was a click & the monitor went black, ive tried stripping down to bare bones etc but still no beeps or posting i also changed the psu from 250 to 500 watts, unfortunately my mb is a bit of an enigma so its hard to find decent info on it, i think the amibios chip is the soldered type, is there any hope or is the board dead? any advice would be greatly appreciated im ok at building systems but bios is out of my league, many thanks
MB-MS-6775 ver1.00/AMIBIOS-686-1999 SH44 2557
I seem to have a problem similar to a lot of others ie black screen, all fans & drives working etc mine came about after upgrading my agp graphics, the HD 2400 pro 512 sapphire was stuttering when i was playing 3D games so i followed the manuals instructions to try & improve system performance! the changes made were as follow: set internal cache to enabled/set bios cacheable to enabled/set 32k shadow to enabled/set fast command to ultra/set fast R2R turnaround to enabled/set agp to fast write enabled & the aperture to 256 so far so good! I then changed the graphics from pci to agp & there was a click & the monitor went black, ive tried stripping down to bare bones etc but still no beeps or posting i also changed the psu from 250 to 500 watts, unfortunately my mb is a bit of an enigma so its hard to find decent info on it, i think the amibios chip is the soldered type, is there any hope or is the board dead? any advice would be greatly appreciated im ok at building systems but bios is out of my league, many thanks