Ho kay , if were all stitting comfortablyi shall begin :
I'm running a small network , for my own fun , and i add terminal as often as i can. My new'est one is a M-520 mother board and thats it. I have enuff parts riped from terminal that died on me to make a new one. SO this is what i have added to " try " and get her up and running
BIOS:
AWARD PCI/PNP 586
S/N 05065283 V
Processor:
IBM 6x86 P166+
(IMB26 6x82-2v7P166GE)
( 133MHz/3.5v )
However , when i give her some power , she just sits there. Hard Drive light stays on and PC spk just beep on , off , on off. Does any one know what is wrong?? Me thinks its one of two things
ONE :
Shes does like the Prosessor so wont work for me.
or
TWO:
The BIOS / CMOS or jumper setting are screwd.
....
..........help??
My M520 is dead and I'm so very witty...
Reseat the memory.
Patched and tested BIOSes are at http://wims.rainbow-software.org
UniFlash - Flash anything anywhere
UniFlash - Flash anything anywhere
Reseat=take out, put back in carefully ensuring it is pressed fully into place.
Disconnect all drives and see if that helps.
Disconnect all drives and see if that helps.
Tested patched BIOSes. Untested patched BIOSes.
Emails *will* be ignored unless the subject line starts "Wim's BIOS forum"
Emails *will* be ignored unless the subject line starts "Wim's BIOS forum"