Page 1 of 1
1 mobo dead, ==> hot-swap, = 2 mobo dead ¡?
Posted: Sat May 17, 2003 6:41 am
by Rorro
Hello.
I' ve been using hotswaping of bios with irregular results.
I did revive a dead m810lmr, with atmel 49F002NT, using a KTVKQ, with amic bios chip. Wonderful to se again the ugly ami bios presentation.
But my problem is that sometimes, after hotswaping, the good mobo is dead too.
¿ Could anyone please tell me the real procedure to make it a safe operation?.
Besides, only the computers with the option "Cache BIos Rom" enabled can be used to hotflash?.
I ask this because I broke an old 486 hotflashing, and it doesn´t give the option in the bios setup screen.
I really need instructions, because I don't want to end with a pile of junk boards.
Thanks.
Posted: Tue May 27, 2003 7:47 am
by edwin
? I haven't managed to kill a board hotflashing other than putting in the chip backwards
so ever since I use a white marker and put dots on the board and the chip so I know its original orientation...
Posted: Wed Jul 23, 2003 11:23 am
by dodo
you mobo is dead after hot-swapping, poor you.
in this thread I want to share my experience flashing BIOS.
I own J-656 VXB board, jetway, but the board get the wrong BIOS <see "flash BIOS changes BIOS ID" topic> and also I own PC-Chips mobo with the same mobo chip Intel VX.
First, I try to flash jetway with my PC-Chip BIOS, the result It can't run fine, it can boot, but there are some error such as serial I/O port.....
next day this system is dead, no beep, but all keyboard LEDs flash. other news is I get the correct BIOS file.
in the other hand, the PC-Chip can't run smoothly, CMOS battery error.
this board get its battery soldered directly to VIA chip's pin(duno what the function of this chip). One day I unintentionally damage the joint between battery and VIA chip. the worst the PIN damaged too and the more worse I can't solder it anymore because the chip pin is gone.
back to the jetway, I try to hot-flash its bios in PC-Chip board, the obstacle I can't change the CMOS <cached option>since batt CMOS error.
then I decide to give it a shot, why not....
fisrt attempt, the system was booted to DOS then I replaced the BIOS chip carrefully, next the screen get disturbed , the blinking cursor is jump to other line, I couldn't input any command. I shutted down; place the original BIOS chip.
second attempt, nothing change.
last attempt, if it's not worked, i won't try it anymore.
luckily everything went fine, after replacement I can input command, I type uniflash bla...bla...bla...bla...
finish hot-flasing I put jetway's BIOS back, and voila! the system work good. I can say so many improvent than the wrong BIOS.
next experiment I try to make dead mobo alive. I own SiS620 chip and will ask for my friend's dead mobo. I promise I will tell you if this mobo can be used again.
last word, i ask your support in this forum.
thanks