Page 1 of 1

winbook won't boot

Posted: Sun May 05, 2002 3:51 am
by cosjohn
HI
My winbook xl 233 mhz won't boot up. I had some trouble reading the c drive, so I cut all power, pulled it out and cleaned it with electronics cleaner. When I put it back in, I couldn't boot up. When I power up, the start lights flash, I hear the c: start running, the processer gets warm, but that's it. No monitor, no bios code, no cd rom, it doesn't scan the a: Nothing happens. I tried to reset the cmos by removing the jumper on j
19, powering up, shutting down and replacing the jumper, but it didn't help. Can anyone help me? Should I junk the laptop?

John

Posted: Sun May 05, 2002 12:07 pm
by edwin
which electric cleaner did you use and how much time did you allow the laptop to dry?

Posted: Tue May 07, 2002 2:18 pm
by cosjohn
edwin wrote:which electric cleaner did you use and how much time did you allow the laptop to dry?
The product is called Imperial pro circuit board cleaner. It contains dichlorofluoroethane, co2 and isopropanol. I did spray some on the motherboard near j19 and the battery (which is soldered to the motherboard).

John

Posted: Tue May 07, 2002 2:19 pm
by cosjohn
cosjohn wrote:
edwin wrote:which electric cleaner did you use and how much time did you allow the laptop to dry?
The product is called Imperial pro circuit board cleaner. It contains dichlorofluoroethane, co2 and isopropanol. I did spray some on the motherboard near j19 and the battery (which is soldered to the motherboard).

I gave it about 3-5 min. to dry.

John