Page 1 of 1
EP-MVP3C BIOS ROM Checksum Error. Diskette stops after 2 sec
Posted: Tue Mar 30, 2004 10:13 am
by aarekk
I have EP-MVP3C EPOC MOBO. My BIOS upgrade failed. (AWDFLASH finished successfully, but after reboot I saw "BIOS ROM Checksum Error" Message and system required system diskette. I prepared bootable system diskette with awdflash.exe, my previous version of BIOS in .bin file, autoexec.bat with proper command to run awdflash. System starts to read from the diskette and after 2 seconds stops. I am sure that there are no bad sectors on the diskette. Thank you for any helpful advices.
Aarekk
Posted: Tue Mar 30, 2004 12:05 pm
by sulbert
Does it boot to DOS if you use a normal DOS boot diskette?
Posted: Tue Mar 30, 2004 1:34 pm
by aarekk
No, it doesn't unfortunately.
Posted: Tue Mar 30, 2004 4:42 pm
by sulbert
You can try to use an old ISA I/O card.
Posted: Tue Mar 30, 2004 8:10 pm
by aarekk
I'll try if I find some. I've already tried to use Caldera DR-Dos boot diskette. I got "Can't load bdos krenel file: A:\IBMDOS.COM System halted." It seems as only the beginning part of dos can be loaded from diskettes...
Posted: Wed Mar 31, 2004 3:06 pm
by KachiWachi
Did you clear CMOS?
What about trying the AWARDBoot disk that is posted here (somewhere)?
Posted: Wed Mar 31, 2004 3:30 pm
by sulbert
KachiWachi wrote:What about trying the AWARDBoot disk that is posted here (somewhere)?
Do you mean the
AWDblock utility? It has a bit other purpose.
I'd try another floppy and/or FDD drive.
Posted: Thu Apr 01, 2004 3:35 pm
by KachiWachi
Yeah...that's it.
I thought it might be able to let him do a bit more diagnostics...assuming his hardware was good prior to the flash...which I have no reason to doubt.
