Page 1 of 1
Asus CUSL2 dead after upgrading BIOS
Posted: Wed May 15, 2002 9:10 pm
by techsurfer
I have an asus CUSL2 motherboard which had version 1001a BIOS on it. I saved this version on a floppy (made bootable in Win XP) and flashed it using the aflash application that came with the board to version 1009 which I downloaded from asus's website. The flash was successful but when I restarted the computer no screen appears - the only thing that happens is that both my CD-ROM & CD-R drives disc read lights light up momentarily and then the hard drive light appears for a while. I tried putting the booteable floppy with aflash in but it won't read it. I don't know what to do! Can you help?
Posted: Wed May 15, 2002 9:27 pm
by soupy
You have the built-in video version and an AGP card? Switch your monitor to the built-in, then reconfigure in the CMOS setup for your AGP card.
Posted: Wed May 15, 2002 10:50 pm
by edwin
If it comes to flashing a bios I usually go back to bare setup:
power supply
board
cpu
as little memory sticks as possible
video (if onboard available, remove any extra cards) +monitor
floppy drive
keyboard
then I start building. A bios flash is usually needed when setting up/adding new hardware so the case is open anyway...
Posted: Sat May 18, 2002 10:05 am
by techsurfer
I think I need to reset my CMOS so that the new BIOS can work but I don't have a clue how to do this - since I can't get into setup. Is there a switch or something on my motherboard to do this?
Posted: Sat May 18, 2002 11:20 am
by Rainbow
Read the manual. There are usually 2 solder points on Asus boards which needs to be shorted for a while while the power is OFF.
