Page 1 of 1
Jumper setting to use ATX P.S.U. with SY-5SSB Soyo M. B.
Posted: Sat May 06, 2006 7:18 pm
by cuervo1
I can't find it on this board. It has both sets of connectors. The User Manual has no setting for it.
Thanks,
B.K.
Posted: Sat May 06, 2006 11:12 pm
by Denniss
Usually only plug-in the ATX connector and it should work.
ATX P.S.U. with SY-5SSB
Posted: Mon May 08, 2006 11:27 pm
by cuervo1
Thanks Denniss:
I tried that,also,checked the P.S.U. It's O. K. I don't think that Soyo is going to answer for a M.B. this old. I tried them. I think that my best bet is that someone on some forum will remember.
B.K.
Posted: Tue May 09, 2006 12:55 am
by cp
from the mainboard manual:
"6.ATX Power On/Off Switch
Attach the 2-pin momentary type switch to the PWRBT connector for turning On or Off your ATX power supply."
it's on the front panel connector.
Good Morning Denniss:
Posted: Tue May 09, 2006 5:28 pm
by cuervo1
I tried that. One of the pins is ground the other has a high resistence ground. Something is keeping the PSU from starting becaus when I short the green wire it runs normal.
Thanks,
B.K.
Posted: Tue May 09, 2006 10:22 pm
by edwin
Only the board connected with CPU and memory? No drives add-in cards/cabling yet? Any of those can be the problem. Another thing, shorting the green wire and have a spinning fan on the PSU is NOT a guarantee it is good. I have just kicked out a PSU that did just that, spin the fan but no output.
P.S.U. checks 0ut.
Posted: Tue May 16, 2006 6:17 pm
by cuervo1
The Power supply runs another board and the P.O.ST. card gives the voltages an o.k. Iv'e tried to trace the starting pins with continuity but without a schematic it's hopeless.
Thanks,
B.K.
