Page 1 of 1

Cmos Settings Wrong

Posted: Sat Sep 16, 2006 4:19 pm
by Everyone
Ok I'll try to explain this in english, and any help would be very much appreciated :)

Yesterday, I had like 2 short powerbreaks to the house, Like just when the ligts and tv and all flashes, goes off and comes on in like a milli sec. I had 2 of those within one second.

So my workstation rebooted itself.

When it came back, "Cmos Settings wrong"

And the old man that I am was going, whohoo I've heard of that. So I go looking through my manual and find the CMOS switch, and I reset the switch.

and yet again, "Cmos Settings wrong".

ok So then I went into the Bios, "Loaded Default Settings" and rebooted it.

Since then I havent gotten into the bios anymore :)

So I read on your forums that when you get the CMOS settings wrong and the reset doesnt work all you need to do is replace a battery.

Think this is the case here ?

Or sorry, motherboard is fried, get a new one ?

or all hope is lost ? New computer yes please.

Motherboard: 865PE Neo2-p

Bios: sorry don't know, the same one wich came with the board.

Posted: Sat Sep 16, 2006 4:33 pm
by edwin
"Since then I havent gotten into the bios anymore". You can't? And the board is no longer booting? No picture at all when resetting the system?

Posted: Sat Sep 16, 2006 4:44 pm
by Everyone
well, now I get the graphics when booting(had disabled that, but when I loaded the default settings, the picture came back, so I can't see the "press del to enter bios setup" or detecting of hardrives.

"Corecell-extreme chip you've ever needed" the nifty image says (if it's so extreme, please boot properly!)

But yes, when i try to hit "del" to enter bios setup, it just beeps and continues, then it beeps twice, giving me the cmos error message.

(edit:) I also end up with the menu:
F11: Bootmenu F12: Network Boot F10: Flash recovery

Press F1 to Resume
Press F2 to load default values and continue

(Tried all options without any success)

Posted: Sat Sep 16, 2006 6:32 pm
by Everyone
Problem solved

Ordered a new motherboard :)

Posted: Sat Sep 16, 2006 7:10 pm
by edwin
I feared as much.