Page 1 of 1
Manual for Full yes or Nimble VX Board Bios 2A59GF3AC
Posted: Wed May 29, 2002 7:31 pm
by John Weber
I have a Full Yes manual but the J18 jumper is incorrect.
I assume it is a Nimble Board Want to upgrade to P55C Processor
MMX 200.
Thanks
John
Posted: Wed May 29, 2002 7:50 pm
by Rainbow
I have something but don't know if it's your board. See
http://rainbow.host.sk/myfiles/FYI%20430VX/
Manual
Posted: Wed May 29, 2002 8:37 pm
by John Weber
Thank You.
That is very close except there is 1 difference.
My board has 3 jumpers available on a J18
but there is no J13 with 2 jumpers. That should be the core voltage but I don't want to burn out my MMX processor. If I don't get any response I will try the Jumpers for J13 the same as J18.
All the other jumpers look identical.
82430 VX Board Full Yes Board
Posted: Thu May 30, 2002 10:01 pm
by John Weber
The motherboard I have is a Rev. A There appears tp be only 1 voltage regulator on the board and the jumpers for J18 are on 1-2 (3 of them)
The manual for the rev A2 and A3 says J13 (rev A J18) says that jumper
2-3 for 2.8 volt core. I don't have that. Is it possible that the Rev. A board did not support an MMX processor?
Posted: Thu May 30, 2002 11:48 pm
by Rainbow
I don't have that board and know anything about it - but it's the earliest revision so it's possible.
