Page 1 of 3
Bios udate for i440BX-ITE867-2A69KS2IC-00
Posted: Fri Oct 15, 2004 7:14 pm
I need an update for this bios :
Award Modular BIOS v4.51PG
Intel 440BX/ZX rev 3
please help me
Posted: Sat Oct 16, 2004 1:45 am
Latest Bios seems to be 2BA6 - 5 versions newer than yours
Posted: Sun Apr 30, 2006 3:37 pm
Please , can u help me in finding the links for downloading the updates??
Posted: Sun Apr 30, 2006 5:34 pm
Posted: Tue May 02, 2006 10:41 pm
Hello, and thanks for the link to the bios update.
Unfortunatelly I got another problem.
I flashed my bios with an old one that I found. The pc , started with the new bios , but I always had the problem with the memory recogniction.(It went worst. Onlt 64gb of 124 where recognized).
So I flahed the bios to the other one , but when I started the pc I got
1 long beep followed by 2 short beeps , and the screen was black . I searched for the soluytion and I found that it could be a memory problem or video card problem. I tried to remove the video card and reinstalling it or remove the memory cards and reinstalling it , but I keep getting black screen and 1 long beep followed by 2 short beeps .
Is there any way to know if I destroied my memory cards or video cards??
Do u suggest something ??
thank u for your time
Posted: Fri May 05, 2006 1:57 am
Have you tried clearing CMOS?
Posted: Fri May 05, 2006 5:24 pm
how do i clean it ??
Posted: Fri May 05, 2006 7:35 pm
From the manual:
CMOS Clearing (JP5)
After you have turned off your computer, clear the CMOS memory by momentarily shorting pins 2-3 on jumper JP5, for a few seconds.
Then restore JP5 to the initial 1-2 jumper setting in order to recover and retain the default settings.
Jumper JP5 can be easily identified by its white colored cap.
Posted: Sun May 07, 2006 3:08 am
I am sorry to bother u , but I can NOT find JP5 jumper.
Could u help me please
Posted: Sun May 07, 2006 4:09 am
my motherboard manual is this:
I can NOT find any reference to the juper jp5.
Canu pls tell me how I could cleaning the CMOS please??
Posted: Sun May 07, 2006 4:19 am
Ok, I dfound it.
I did it , but I still have the same problem. My pc does not start .
can u suggest something else pls ??
Posted: Sun May 07, 2006 7:47 am
Don't forget to change the Clear CMOS jumper back to the normal position after you have used it.
The PC will not start with the Clear CMOS jumper in clear mode.
Posted: Sun May 07, 2006 9:21 pm
Sorry for my bad english.
I started the pc with the jumper in the original position , but I alwayg the same beeps.
Any help please ??
Posted: Mon May 08, 2006 2:23 am
Just a moment... Are you talking about the same motherboard?
Soyo SY-6BA+ III or EPoX EP-61BXA-M?
Posted: Mon May 08, 2006 6:53 am
marcolisi wrote:...but I always had the problem with the memory recogniction.(It went worst. Onlt 64gb of 124 where recognized).
64 or 128
not 124, I fear at least one of your memory cards is bad. Do you have other memory cards you can test?