uniflash success. but computer won't post!!!!!!!
Posted: Mon Jan 20, 2003 12:38 am
Hot swapped chip and used uniflash but now computer won't boot. The system comes up and cdrw lights then hd lights but it goes back and does the same again and again. K7s5a board, xp1800+, 512mb ddr2100 and gforce 2 card. What am I doing wrong. Put back in original chip and board boots fine. 
Broke prong on original chip and using staple to make contact. So far so good but it would be nice to get other chip working if possible. Any ideas or suggestions appreciated.
G. Harper
Broke prong on original chip and using staple to make contact. So far so good but it would be nice to get other chip working if possible. Any ideas or suggestions appreciated.G. Harper
