MS-7061 v1.0 (KM3M-V)
Posted: Wed Feb 18, 2009 9:07 pm
This mobo is attempting to recover the BIOS
I get video stating;
Award Bootblock BIOS v1.0
CMOS BIOS checksum error
The diskette is identified and the disk reads
the recovery files. After the FDD stops being
read, the mobo resets to a C1 checkpoint
and goes throught the recovery process
in a loop until the mobo is powered off.
The FDD and diskette are known good.
Would an initial assessment be the BIOS IC
is broken or malfunctioning?
C1 details bad SIMM. Presume this refers to
the BIOS IC and not DDR SDRAM as if this
were no good, the mobo would issue an alarm
(beep codes). Where C1 if a valid bootblock
exists, it will try to recover BIOS.
I suspect the recovery process is not working
correctly. Result, replace the BIOS IC or at
the very least reflash.
However, the BIOS is soldered not socketed
Any suggestions?
Thanks
I get video stating;
Award Bootblock BIOS v1.0
CMOS BIOS checksum error
The diskette is identified and the disk reads
the recovery files. After the FDD stops being
read, the mobo resets to a C1 checkpoint
and goes throught the recovery process
in a loop until the mobo is powered off.
The FDD and diskette are known good.
Would an initial assessment be the BIOS IC
is broken or malfunctioning?
C1 details bad SIMM. Presume this refers to
the BIOS IC and not DDR SDRAM as if this
were no good, the mobo would issue an alarm
(beep codes). Where C1 if a valid bootblock
exists, it will try to recover BIOS.
I suspect the recovery process is not working
correctly. Result, replace the BIOS IC or at
the very least reflash.
However, the BIOS is soldered not socketed
Any suggestions?
Thanks