Interrupt conflict with networkadapter?
Posted: Fri Feb 21, 2003 6:52 pm
Hi everybody,
I am trying to install a networkadapter(typhoon, 10/100 Fast ethernet PCI) to my old PC (win95, award).
After installing and reset the win95 startup halts with blinking cursor. Sometimes it works almost, but after changing some configurations the same it halts again.
The manual of the Nadapter says that it is possible that there might be an interrupt problem, due to assignig same number for several devices. In fact the interrupt no 11 is assigned to IRQ holder, too.
Now my question is how to adjust interrupts manualy?
Or is that rather useless?
Thanx to all repliers
I am trying to install a networkadapter(typhoon, 10/100 Fast ethernet PCI) to my old PC (win95, award).
After installing and reset the win95 startup halts with blinking cursor. Sometimes it works almost, but after changing some configurations the same it halts again.
The manual of the Nadapter says that it is possible that there might be an interrupt problem, due to assignig same number for several devices. In fact the interrupt no 11 is assigned to IRQ holder, too.
Now my question is how to adjust interrupts manualy?
Or is that rather useless?
Thanx to all repliers