Put same system back together now won't work

How-to identify your motherboard ?
Post Reply
headspun
New visitors - please read the rules.
Posts: 2
Joined: Sun Nov 17, 2002 2:35 pm

I bought a new system and decided to get my old one going again so put it back together put the same cd -rom that I was using in my new sys back into it,a secondhand floppy(which has tested ok),turned it on and the drive comes up as primary slave,it doesn't recognize the cd-rom and I get the message " boot disk failure,insert system disk",do that and get message that it's got the driver for the cd-rom but then "no drives found,aborting installation".
Run fdisk,get message, error no fixed disk found.
I hooked the two computers together and checked the drives for viruses which was ok.
I copied win98 to that drive from main computer and had that going but couldn't get the cd-rom to go, strange, as it was all working ok.
So i formatted that drive disconnected the computers and was going to setup win98se,turned it on, exactly the same.
Denniss
BIOS Guru
Posts: 3153
Joined: Thu Mar 21, 2002 8:16 pm
Location: Near Hannover (CEBIT) Germany
Contact:

Check jumpers and cables of your HDD/CDROM !
With 80 wire UDMA cable use blue end at mainboard and black end at master drive - if WD drive with no other drive on the same cable do not set Master or slave jumpers
Post Reply