BIOS Updates forum

Hy there I am running the K6-III downto 2,0 V, wich is very confusing to me, because my P233-MMX (normally 2,8V) also runs at 2,0V.... However I have the BIOS formerly installed on the Flash-BIOS-Chip. This is a 2.1 version, but is differs from the 2.1 I downloaded from Gigabyte. Them I also downloa...

Hy there Now I got a new problem. This damend board :evil: doesn't run with my K6-III 400. 66MHz x2 @ 2,4V (all downto 2,0 V seem to start). When BIOS finished POST someting like "Updating ESCD..." sould be displayed, followed by "Success". (At least a P233MMX does it.) The K6 boots up (one beep and...

Hy Folks It was right. L6 was the same. Because the USB-plug has two USB-ports there was the same group of parts on the other side of the plug. L6 was a "ferrit"with 0,02Ohm and 0,5µH. I replaced it with a new one and all is ok now. :D I still wonder why Gigabyte came to the idea to do the pinout of...

Hi there I have a problem. I unfortunately put a wrong rear-USB-bay (+cable) to my Mainbaord GA-586 TX3 Rev. 1.09. When switched on the part with the print "L5" besides the USB connector burned. :? The mainboard is still running fine, but the part is blown. The USB is dead. :cry: Can anyone please h...