BIOS Updates forum

I've specification of memory modul for BVD2A. It should be: 1. 3,3V 2. unbuffered or registered 3. 64/72 bit SDRAM with SPD it can be: 1. single or double sided 2. from 8 to 256 MB 3. with or without parity Each data bank has 64 bit data path. Is somethink special in this specification? What is SPD ...

Thank you Edwin for this link. The Crucial Memory Selector will not help me. There is no Procomp on the list of systems manufacturers. I'll have to write to Procomp's support for memory specification. I've one more idea about this problem. Is't possible, that CPU's cache is bad and makes this proble...

I tried brand new PC133. When I put it into first slot the PC didn't boot. Then I removed memeory. Board's message: no memory. I instaled the dimm into third slot. PC started, but with default bios' settings. I entered setup and disabled virus detection, enabled fast check at sturtup, etc. I didn't ...

So, If I get P III on 100 MHz all should be OK? This way is easier for me than looking for memory that will work. As I wrote - the chips on memory are marked 6 ns, so it should work even at 166 MHz... Zorro P.S. Bay the way, how it is possible the memory is bad at 133 as I checked it with Memtest86 ...

Dear Experts, I have Procomp BVD2A mainboard, bios 2.00 vertion. With Celeron 433 it works perfectly. When I install P III 667/256/133/1.65V I get such behaviour: 1. First booting. AGP card activates. Message: BIOS ROM checksum error, :? and floppy seek from boot block. When I put celeron back the b...