BIOS Updates forum

i had a similar problem some time ago... maybe try unprotecting the boot diskette, and if enabled, disable the 'floppy write protection' function on the bios setup (if available)

sorry about that... you're right, it's a v7.1c, as said in the bios ID and in the BIOS sticker...

Is there any way to enable AGP fast writes on these motherboards? they are the ones with integrated processors (this one is the one labeled as Pro 1400+, which is a 950 MHz Duron oc'ed to run @ 1 GHz) the thing is, I recently bought a 128mb ATi RADEON 9200 AGP card for this motherboard (Asus A9200SE...

the results couldn't be better: the bios chip was dead, so i couldn't reflash it... so i bought a new empty chip, flashed it and solved the problem...

thanx for all the tips,

LT

well then i'll try restoring the bios and will post the results in a week or two...

thanx

LT

thanx for the tip...
one more question: will i be risking the m810 if i do the hotflash method in it???

thanx in advance

LT

thanx for the advice
if i cant reflash the bios with the 560, then will a m810l 7.1 do the job?

thanx in advance...

LT

i need to reflash a dead pcchips m800lmr with the hot-swap (or whatever its name is) method. i already did it before, so i just need some data: 1. voltage of the 'atmel 49f002nt' flash rom to be able to flash it 2. can i use a m560tg motherboard to reflash the bios using the hotswap method (i don't ...

i know this hasn't got to do with BIOSes, but i have a doubt: how can I change the little msg that appears under my nickname in my posts; eg: my posts say: Luncheon Ticket New visitors - please read the rules. but, for instance, in Rainbow's posts say: Rainbow The Uniflasher do i need any special ri...

just a couple of questions... can anyone tell me the RAM cachability limit of a M560TG mobo (ALi 1543 - 1531) do u know any websites about this kind of info?

thanx in advance,

L.T.

if you have a PCChips M537DMA33, then you can run up to two PC133 256MB SDRAM DIMMs (after updating the bios of course). but i have had stability probs with this type of DIMMs, so I recommend you to use, as a maximum, PC100 128MB SDRAM DIMMs...
hope this helps...

regards,

L.T.

thanx for the tip rainbow, but the flasher you told me to try doesn't work either and coughs a similar error msg than the other app: Unknown EEPROM (Manufacturer ID: 55h, Device ID: AAh) notice the different Man. IDs in both apps... what is that supposed to mean? the flasher utility found on 3dfxbio...

this is the problem, games like Half-Life, CMR2.0 and NFS5 seem to run fine in d3d, but Israeli Air Force and many others just freeze... i tried to disable L2 Cache as suggested in some 3dfx sites, but it didn't make any difference... i guess i should try to flash the card's bios and see the result....

the chip is a MX28000PQC. if anyone knows where can i find the right app for that chip, please let me know...
thanx in advance,
L.T.

i downloaded the right bios file for my card: PCI Banshee w/ SDRAM but the 3dfxflash app refuses to flash the bios and coughs the following msg: Unknown EEPROM (Manufacturer ID: C2h, Device ID: AAh) is there any way to override this? do i need a newer version of the 3dfx flash app? the chip is a MX....