Its a sad combination apparently my memory couldnt handle a 200 mhz fsb with the tweaks from the custom bios.
Now I am totally unable to get passed the C1 (memory) error that the diagnostic LED is giving me on boot up.
When I start the pc everything powers up as usual (fans cd's harddrives floppy).
The LED goes through these codes: FF -> C3 -> C1 and halts here every time.
Point is that it doesnt even get to the point where its sposed to read a emergency flash disk...
Sooooo do I have to get this one repaired?
Or do a bootblock attempt ? (have no idea what to short on the plcc)
Or wait a week and try a hotflash when I get an frn2-l back (is that possible with these 2 boards?)?
Any help would be appreciated
8rda3+ and custom bios
Have you tried clearing CMOS? Or does the custom BIOS fix the FSB at 200MHz?
Tested patched BIOSes. Untested patched BIOSes.
Emails *will* be ignored unless the subject line starts "Wim's BIOS forum"
Emails *will* be ignored unless the subject line starts "Wim's BIOS forum"