I'm troubleshooting a couple-of-years-old Celeron PC of which the invoice says:
"MB Protac 5370 ATX+ sound"
There is a copper cooling plate that sais "Matsonic MS7192S"
the PC runs Win ME
it has a double on-board USB, which recognizes the attached equipment (I can install drivers), but sends error messages on use of the USB devices: "cannot find USB device, check cable"
Cable & device work perfectly on other equipent, running same OS, same SW, ...
could something like this be solved by BIOS update ?
something in BIOS I need to set op ?
other suggestions ?
thnx !
Dirk.
Matsonic or Protac ? USB prob also BIOS prob ?
-
- Master Flasher
- Posts: 197
- Joined: Thu Mar 21, 2002 7:26 pm
- Location: Airdrie, Alberta, Canada
Appears to be Matsonic MS7192S - Slot 1 or socket 370 motherboard. Info at the following links:
Manual - http://www.matsonic.com.tw/manual/ms7192s.pdf
BIOS update, 71920722.exe, BIOS Rev. 07-22-99 - http://www.matsonic.com.tw/eng/update.htm - ms7192s
In the manual for the BIOS Setup section - Integrated Peripherals Setup Page, USB Controller – Use this item to enable or disable the onboard USB ports.
I suspect you already have this enabled, but it may be something to check. I don't know if any of this will help but it may be a start.
Manual - http://www.matsonic.com.tw/manual/ms7192s.pdf
BIOS update, 71920722.exe, BIOS Rev. 07-22-99 - http://www.matsonic.com.tw/eng/update.htm - ms7192s
In the manual for the BIOS Setup section - Integrated Peripherals Setup Page, USB Controller – Use this item to enable or disable the onboard USB ports.
I suspect you already have this enabled, but it may be something to check. I don't know if any of this will help but it may be a start.