no video/ power supply

Hot-swapping and Boot-Block flash & Boot block flash and floppy support
Post Reply
stillsleep
New visitors - please read the rules.
Posts: 2
Joined: Thu Dec 19, 2002 10:42 am

my power supply blew and i got a new one after i installed it i went to turn the computer back on and i had no video. i cpu powers and the drives start to run but i can't see anything. someone told me to clear the cmos so i did that. i was also told to reseat the ram and video cards. i did that and still no luck. i believe it is a bios problem but don't know how to fix it. it's a spacewalker with a petium 2 in it. and i have tried other video cards but they didn't work either.
Rainbow
The UniFlasher
Posts: 3122
Joined: Wed Mar 20, 2002 4:16 pm
Location: Slovakia
Contact:

I'm afraid that the PSU burnt something... Test all components separately to find which ones are bad.
Patched and tested BIOSes are at http://wims.rainbow-software.org
UniFlash - Flash anything anywhere
stillsleep
New visitors - please read the rules.
Posts: 2
Joined: Thu Dec 19, 2002 10:42 am

i pulled everything out but the mother board and the floppy. the floppy runs but still nothing. not sure what you meant by pulling everything but i think this is what you meant if not please clarify.
NickS
BIOS Bodhisattva
Posts: 3145
Joined: Fri May 03, 2002 10:34 am
Location: Thames Valley, UK

Can you test the CPU, RAM and video in another motherboard ?
Tested patched BIOSes. Untested patched BIOSes.
Emails *will* be ignored unless the subject line starts "Wim's BIOS forum"
Post Reply