Manual for Full yes or Nimble VX Board Bios 2A59GF3AC

Request help finding jumper settings or a motherboard manual.
Post Reply
John Weber
New visitors - please read the rules.
Posts: 3
Joined: Wed May 29, 2002 7:23 pm

I have a Full Yes manual but the J18 jumper is incorrect.
I assume it is a Nimble Board Want to upgrade to P55C Processor
MMX 200.
Thanks
John
Rainbow
The UniFlasher
Posts: 3122
Joined: Wed Mar 20, 2002 4:16 pm
Location: Slovakia
Contact:

I have something but don't know if it's your board. See http://rainbow.host.sk/myfiles/FYI%20430VX/
Last edited by Rainbow on Thu May 30, 2002 8:36 pm, edited 2 times in total.
Patched and tested BIOSes are at http://wims.rainbow-software.org
UniFlash - Flash anything anywhere
John Weber
New visitors - please read the rules.
Posts: 3
Joined: Wed May 29, 2002 7:23 pm

Thank You.
That is very close except there is 1 difference.
My board has 3 jumpers available on a J18
but there is no J13 with 2 jumpers. That should be the core voltage but I don't want to burn out my MMX processor. If I don't get any response I will try the Jumpers for J13 the same as J18.
All the other jumpers look identical.
John Weber
New visitors - please read the rules.
Posts: 3
Joined: Wed May 29, 2002 7:23 pm

The motherboard I have is a Rev. A There appears tp be only 1 voltage regulator on the board and the jumpers for J18 are on 1-2 (3 of them)
The manual for the rev A2 and A3 says J13 (rev A J18) says that jumper
2-3 for 2.8 volt core. I don't have that. Is it possible that the Rev. A board did not support an MMX processor?
Rainbow
The UniFlasher
Posts: 3122
Joined: Wed Mar 20, 2002 4:16 pm
Location: Slovakia
Contact:

I don't have that board and know anything about it - but it's the earliest revision so it's possible.
Patched and tested BIOSes are at http://wims.rainbow-software.org
UniFlash - Flash anything anywhere
Post Reply