BIOS Updates forum

because of many crashes of the system i think a new bios will make it better.
i've looked at http://www.ncr.com/support/support_driv ... brary_3232 for a bios-update for my Globalyst 510. but there was only one for the G515. is that compatibel to the G500?

thank you for your help!
maximilian

hey, do you have a notebook?
i've had this problem too with my notebokk with SiS 630 chipset. after 3 reeboots there was no problem longer. and with the driver i think you need the full package of SiS drivers. first you should install the AGP104 driver, and then the 206_win2k_630 (?) graphics driver.

ok, i will try it with your good information.
and, i've removed the label of the square chip. there is printed:
TSENG LABS
ET3000AX
11038F-0005
JAPAN 8927EAY

thank you for your help...
maximilian

i've uploaded some pictures of the graphics-card at http://home.knuut.de/Ma.Lange/Mix/gfx-card.htm

oh, it's a little bit difficult to translate the specific words into german
but i think you also tried to overclock these 486? is it possible?

this video-card has a vga and a monochrome port. but i don't know how to activate the right port, because there are 4 switches.
i tried both ports. onece with vga and then with black-and-wite.

have i to cool my old 486DX2-50MHz processor? or is it possible to overheat it without a cooler?

yes, i've disabled the onboard graphic-chip. i now think the problem is with the external graphic-card. i don't have any informations about it, and how to set the jumpers. i think the manufacteur of the card is TLI USA an the type is P/N 8822 or NM1 94V-0 or 59-6679-0005. more can't i find on the gr...

i've an old AT&T globalyst-510. i will integrate an old Monochrome grafik-card, because i will use an old monochrome display (9pin connector). but the the external grafik-card don't recognize any monitor / or possible the gfx-card isn't recognized by the globalyst-510.
who can help me?

hey,
if you have bought the notebook, you'll have a handbook. there must be some info about a jumper for deleting the boot passwort.

hy
do you have a boot disk for win98? then you can make new partitions for your old drive. and then format.

hy
I've found a possibility to use the 6GB-HDD!
the primary partition is as big as the BIOS ist supports(500MB) but the other partitions I can make as big as I would like! (2GB) and windows can use these big partitions.
so I don't need any special software or an bios update... (only fdisk)

hy
I need a drive overlay software because my bios don't support the new 6GB HDD ( HITACHI_DK23AA-60 )
can you send me one, please? or where can I find it?